Python Remote Not Locking Doors

Try reprogramming your remotes.

Python remote not locking doors.

Python remote starter wont start the vehicle doors will not unlock with the remote or start the car but will arm the alarm. Sometimes after the battery in the car or remote start fob has been changed the fob won t work until it has been reset. These are your lock and unlock wires blue unlock. Check the remote antenna inside of your vehicle.

Then the daylight running headlights would not work or the keyless entry. If the remote is not responding to you there is a good possibility you just need a battery for it. Look on the back of your remote for the proper buttons to press to enter and exit valet mode usually lock trunk. Try the lock button trunk release button or panic button.

Try holding the fob right next to the door handle when pressing the unlock button. In december i had a remote start installed in my truck and am using the original truck key fobs to start the truck. When placed in this mode the security system will arm itself 30 seconds after the customer leaves the vehicle. I used the remote start almost daily without any issue.

The problems started when i went to use the remote starter afew weeks ago and the alarm went off and i had to shut it off by starting the car with the key. Even if you forget to arm the system passive arming will protect the vehicle from would be thieves. The fob would not lock or unlock the doors. Make sure that the connecting harness is fully secured.

Python s remote start system allows users to operate their power locks and start their vehicle with the simple push of a button. These should be going to a blue green wire lock and a yellow red wire unlock in the driver side kickpanel. If it unlocks the door the problem may be a weak battery in the key fob or a problem in the keyless entry antenna or wiring. In january i remote started my truck and when i went to get into the vehicle the key fob did not open the door.

This feature can be used in conjunction with power door locks and windows to fully secure the vehicle. When you press these buttons the parking lights should flash two times. Your remote might also have lost programming. The key fob itself could be defective or have a bad unlock button.

Step 1 sit in the driver s seat and close all of the doors. If you own one of the high end compustar remotes that have internal batteries then it needs to be charged. If lock unlock does work please proceed to the next troubleshooting step. If your remote has usb port plug it into a usb charger and then try again later.

Also the vehicle would not shut off when i took the key out of the ignition had to repeat it to get the car to shut off.